RPC32
Сообщений: 3
Оценки: 0
Присоединился: 2011-01-21 12:57:49.386666
|
Не могу выполнить "airodump-ng"
root@bt:~# iwconfig
lo no wireless extensions.
eth0 IEEE 802.11bgn ESSID:"" Nickname:""
Mode:Managed Frequency:2.457 GHz Access Point:
Not-Associated
Bit Rate:16 Mb/s Tx-Power:24 dBm
Retry min limit:7 RTS thrff Fragment thr:off
Power Managementmode:All packets received
Link Quality=5/5 Signal level=0 dBm Noise level=0 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
root@bt:~# airodump-ng eth0
ioctl(SIOCSIWMODE) failed: Invalid argument
ARP linktype is set to 1 (Ethernet) - expected ARPHRD_IEEE80211,
ARPHRD_IEEE80211_FULL or ARPHRD_IEEE80211_PRISM instead. Make
sure RFMON is enabled: run 'airmon-ng start eth0 <#>'
Sysfs injection support was not found either.
при вводе "airmon-ng start eth0" выбивает:
Interface Chipset Driver
eth0 Broadcom wl (monitor mode enabled)
хотелось бы услышать решение данной проблемы (желательно пошаговое)
|
Беда с WEP взломом - 
